Eurocode 7 - geotechnical design

Q1. Please provide your contact details in case we need to clarify your submission. (These details will be kept strictly confidential.)

Q2. How many structures of this kind have you previously designed?

Q3. Having completed your design to Eurocode 7, how confident are you that the design is sound?

Q4. How did you account for the location of boreholes relative to the foundation?

Q5. Please explain the reasons for your answer to Q4

Q6. Which parameters did you use for the SLS design of the spread foundation?

Q7. What correlations did you use to derive soil parameter values (if used) for the SLS verification? If more than one, please list others below.

Q7a. Any other correlations (please give same info as above)

Q8. What assumptions did you make in choosing these correlations?

Q9. How did you account for any variation in parameters with depth?

Q10. Please explain the reasons for your answer to Q9

Q11. What is the characteristic value of N at these depths?

Q12. What is the characteristic value of E_{u} for a linear elastic calculation at these depths?

Q13. How did you assess these values?

Q14. Which calculation model did you use to determine settlement?

Q15. What limiting values of settlement and tilt is appropriate for this foundation?

Q16. What width does the foundation need to avoid a serviceability limit state?

Q17. Which parameters did you use for the ULS design of the spread foundation?

Q18. What correlations did you use to derive soil parameter values (if used) for the ULS verification? If more than one, please list others below.

Q18a. Any other correlations (please give same info as above)

Q19. What assumptions did you make in choosing these correlations?

Q20. What is the characteristic value of c_{u} at these depths?

Q21. Which calculation model did you use to determine bearing resistance?

Q22. Which country's National Annex did you use to interpret EN 1997-1?

Q23. Which Design Approach did you use for verification of the Ultimate Limit State (ULS)?

Q24. What values of partial factors did you use for this ULS verification?

Q24a. If you used a second combination of partial factors, what values did you use for this second combination?

Q25. What width does the foundation need to avoid an ultimate limit state?

Q26. What are the structural forces (at its centreline) that the foundation must be designed for according to Eurocode 2?

Q27. What other assumptions did you need to make to complete your design?

Q28. Please specify any other data that you would have liked to have had to design this type of foundation

Q29. How conservative do you consider your previous national practice to be for this design example?

Q30. How conservative do you consider Eurocode 7 (with your National Annex) to be for this example?

Q31. How does your Eurocode 7 design compare with your previous national practice?

Q32. Please provide any other relevant information needed to understand your solution to this design exercise

©Copyright 2005-16 Geocentrix Ltd. All rights reserved Registered in England, no 3738829 Registered office: 54 Wilmot Way, Banstead, Surrey, SM7 2PY, United Kingdom Use of this website signifies your acceptance of the Terms of Use